Publicidad
Idiomas disponibles
Idiomas disponibles
Cutting aluminum extrusion
When securing aluminum extrusions, use spacer blocks
or pieces of scrap as shown in the figure to prevent
deformation of the aluminum. Use a cutting lubricant
when cutting the aluminum extrusion to prevent build-up
of the aluminum material on the circular saw blade.
WARNING:
Never attempt to cut thick or
round aluminum extrusions. Thick or round alumi-
num extrusions can be difficult to secure and the work
may loosen during the cutting operation which may
result in loss of control and serious personal injury.
3
4
Fig.46
► 1. Vise 2. Spacer block 3. Guide fence 4. Aluminum
extrusion 5. Spacer block
Cutting repetitive lengths
When cutting several pieces of stock to the same
length, ranging from 225 mm to 350 mm (8-7/8" to
13-3/4"), pull up the set plate as shown in the figure.
Secure the workpiece in the position for cutting. Slide
the right sub base so that the set plate flushes against
the end of the workpiece. Then secure the sub base
with the thumb screw.
1
Fig.47
► 1. Set plate 2. Thumb screw
1
2
5
2
25 ENGLISH
Groove cutting
WARNING:
Do not attempt to perform this
type of cut by using a wider type blade or dado
blade. Attempting to make a groove cut with a wider
blade or dado blade could lead to unexpected cutting
results and kickback which may result in serious
personal injury.
WARNING:
Be sure to return the stopper arm
to the original position when performing other
than groove cutting. Attempting to make cuts with
the stopper arm in the incorrect position could lead to
unexpected cutting results and kickback which may
result in serious personal injury.
For a dado type cut, perform as follows:
1.
Adjust the lower limit position of the circular saw
blade using the adjusting screw and the stopper arm to
limit the cutting depth of the circular saw blade. Refer to
the section for stopper arm.
2.
After adjusting the lower limit position of the circu-
lar saw blade, cut parallel grooves across the width of
the workpiece using a slide (push) cut.
1
Fig.48
► 1. Cut grooves with saw blade
3.
Remove the workpiece material between the
grooves with a chisel.
Carrying tool
Before carrying the tool, be sure to unplug the tool and
all movable parts of the tool are secured. Always check
the following:
•
The tool is unplugged.
•
The carriage is at 0° bevel angle position and
secured.
•
The carriage is lowered and locked.
•
The carriage is slid toward you fully and locked.
•
The turn base is at the full right miter angle posi-
tion and secured.
Publicidad
