Publicidad
Idiomas disponibles
Idiomas disponibles
Filling Procedure
1. Unscrew the cap (1) and place it on a clean
surface where it will not collect dirt, dust, grass
clippings, or other debris.
2. Remove the filter basket (2) and remove any
debris. Place the filter basket (2) on a clean
surface where it will not collect dirt, dust, grass
clippings, or other debris.
3. Inspect the tank interior for debris, and clean as
needed.
4. Check to make sure the in-tank filter (3) is in
place, the mesh is intact, and it is not clogged
with debris. See "In-Tank Filter Maintenance" on
page 17.
5. Ensure the shut-off assembly is connected to the
tank. Otherwise, liquid will pour out of the open
connection.
6. Follow the chemical manufacturer's instructions
for preparing the chemical. Fill the sprayer by
pouring liquid into the top opening and through
the filter basket, to the desired volume, according
to the volume graduation markings on the side
of the tank.
7. Clean up any spilled, splashed, or overflowed
liquid on the sprayer.
8. Insert the battery according to the instructions in
Installing the Battery.
Fig. 9
1
2
3
Installing the Battery
WARNING: RISK OF FIRE, BURNS, OR ELECTRICAL
SHOCK. To reduce risk of battery fire or bursts, use only
CMCB202, CMCB204, CMCB206, CMCB209 batteries
that are in good condition. Do not use batteries that
are wet or have been damaged.
WARNING: Prevent unintentional spraying. Ensure
the switch is in the OFF position before connecting
the battery pack, picking up, or carrying the sprayer.
Carrying the sprayer with your finger on the switch or
energizing the sprayer which has the switch on invites
accidents.
CAUTION: RISK OF UNINTENDED SPRAYING. Ensure
the sprayer is OFF and that the shut-off lever is
released before inserting the battery. The sprayer will
spray when the battery is inserted if the sprayer is ON
and the shut-off lever depressed.
1. Ensure the sprayer is on a stable surface and
turned OFF.
2. Open the battery compartment by releasing
the metallic latch attached to the side door, and
swing the door open sidewards.
3. Align the battery (G) with the rails inside the
battery compartment and slide it into the
compartment until the battery (G) is firmly
seated. Ensure it does not disengage.
4. Close the door and ensure that the metallic door
latch (1) is engaged.
Fig. 10
ENGLISH
G
1
2
13
Publicidad
