SATA SATAjet 3000 K Instrucciones De Servicio página 29

Operating instructions SATAjet 3000 K (RP/HVLP)
4.5 Material fl ow control
Adjust material flow control
in accordance with spray viscosity and required flow rate (arrow 1 ) and fix
by means of the counter nut (arrow 2 ). Under normal circumstances, the
material flow control is fully open.
4.6 Round/fl at spray control
Round/flat spray control for right-handed painters
for infinitely variable adaptation of the spray fan to the object:
Turn to the left - flat spray
Turn to the right - round spray
4.7 Nozzle set
Complete, hand-checked nozzle-set, consisting of paint needle (V4A), paint
nozzle (V4A) and air cap. Mount the nozzle set tightly (use universal wrench
for the paint nozzle). Insert paint nozzle before putting in paint needle. The
air cap should be placed in a position in which the marking is on top. Use
punched hexagon socket (wrench size 12) of universal wrench for paint
nozzle. Only original SATA parts guarantee highest quality and lifetime.
When mounting foreign parts, quality reduction is possible and the
SATA warranty expires resp. dangers to your health may occur.
Nozzle sets, jet 3000 K RP version
92494 for SATAjet 3000 K RP 0,8
92502 for SATAjet 3000 K RP 1,1
92510 for SATAjet 3000 K RP 1,3
92528 for SATAjet 3000 K RP 1,5
95422 for SATAjet 3000 K RP 1,7
95356 for SATAjet 3000 K RP 2,0
Test air caps, jet 3000 K HVLP version
95059 Test air cap 0.8 - 1.0 with 2 gauges
95067 Test air cap 1.2 - 1.6 - 2.0 with 2 gauges
4.8 Spray distance
To avoid overspray and surface problems, make sure to paint with the correct
spraying distance between gun nozzle and the object to be painted and to
adjust the spray gun inlet pressure accordingly.
Version Spray distance
jet 3000 K RP 15 - 23 cm/6 - 9 inches
jet 3000 K HVLP 13 - 17 (21) cm/5 - 7 (8) inches 2,5 bar/36 psi
Nozzle sets, jet 3000 K HVLP version
92783 for SATAjet 3000 K HVLP 0,8
92791 for SATAjet 3000 K HVLP 1,0
92809 for SATAjet 3000 K HVLP 1,2
92817 for SATAjet 3000 K HVLP 1,6
92825 for SATAjet 3000 K HVLP 2,0
Gun inlet pressure
2,5 - 3,0 bar/36 - 43.5 psi
2
1
III.5