Amann Girrbach Ceramill Therm Instrucciones De Servicio página 21

_ After starting the programme, the status
indicator LED control system ( and the
heating control lamp light @ synchronously
until the holding time expires. If the furnace
has reached the predefined target temperature,
both LEDs may temporarily go out, as no addi-
tional heating is required due to the permanent
temperature rise in the firing chamber.
_ By pressing the Start key ^ for approx. 2
seconds during a running programme, the
programme is halted. By pressing the key
once again for 2 seconds, the programme
continues. The programme can be stopped by
pressing the Start key ^ for 5 seconds.
Halting the programme
_ By activating the Menu key % during a running
programme, segment information and the
remaining time can be displayed. In doing so,
the cooling period is not taken into account, if
no cooling rate has been defined.
Display of current segment
Display of remaining time
Use the sintering pliers for removal (other
sintering pliers may be used as well)
cautIOn! When removing the bowl, do not knock
against the heating elements with the pliers!
A safety switch interrupts the heating process
when the furnace door is opened! The sintering
program will continue after the door has been
closed again.
cautIOn! Do not open the furnace during the
entire program sequence (frameworks, heating
elements and insulation will receive a thermal
shock)!
gB
21