Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT Quote the information on
the product identification label whenever you
contact an Authorised Service Centre.
IMPORTANT An example of the
Declaration of Conformity is provided
on the last pages of this manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Power unit: it drives the cutting means
through a transmission shaft.
B. Rod: it connects the rear hand
grip to the power unit.
C. Cutting means: the element
designed to cut the vegetation.
1. Cutting line head: nylon
line cutting means.
D. Cutting means guard: it is a safety
device which prevents objects drawn
up by the cutting means from being
hurled away from the machine.
E. Front hand grip: semi-circular shaped,
it is used to handle the machine.
F.
Rear hand grip: used to handle the
machine and equipped with the main
on/off/acceleration control buttons.
G. Battery (if it is not supplied with the machine,
see chapter 15 "accessories on request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
H. Battery charger (if it is not supplied with
the machine, see chapter 15 "accessories
on request"): device used to recharge
the battery. Two battery charger models
are available: H1 (fast battery charge);
H2 (standard battery charge).
I.
Battery backpack (attachment
on request, par. 15.3): device in
which the batteries are placed.
J.
Connection cable: cable used to connect
the machine to the battery backpack.
K. Battery simulator (attachment on
request, par. 15.4): device that, if
inserted in the machine housing, allows
the use of the battery backpack.
4. ASSEMBLY
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
instructions provided in the "ASSEMBLY"
section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.
4.2 ROD INSTALLATION
– Insert and push the lower part of the rod
(Fig. 3.A) in the upper part (Fig. 3.B) until
your hear the stop pin that blocks it in the
right position. The rod can be removed
by pressing the button (Fig. 3.C).
The rod length is adjustable
4.3 FITTING THE FRONT HAND GRIP
– Mount the front hand grip (Fig.4.A) on
the support (Fig. 4.B), tighten it with the
appropriate screw (Fig. 4.C) and lock the
nut on the opposite side (Fig. 4. D).
4.4 FITTING THE GUARD ON
THE CUTTING MEANS
Wear protective gloves.
EN - 8
(par. 6.1.2).
Publicidad
