Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Please read this instruction manual carefully: it contains important information on the
-
safe installation, use and maintenance of the appliance.
If it is necessary to move the appliance at any time, keep it in an upright position; if
-
absolutely necessary, it can be tilted on its back.
Warning:
The installation of tubes and electrical equipment must be carried out by professionals.
Positioning and levelling
Remove the device from its packaging and check that it has not been damaged during
-
transport. If it is damaged, please contact the official Cecotec Technical Support Service
and do not continue with the installation process.
Check the dishwasher and position it so that its sides or rear panel are in contact
-
with adjacent cabinets or even the wall. This appliance can also be installed under an
individual worktop (see installation instructions).
Place the dishwasher on a level and sturdy floor. If the floor is uneven, the front legs
-
of the appliance can be adjusted until it reaches a horizontal position (the angle of
inclination should not exceed 2 degrees). If the appliance is correctly levelled, it will be
more stable and much less likely to move or cause vibration and noise during operation.
Connecting water and electricity supplies
The connection of the water and electricity supplies must only be carried out by a
-
qualified technician.
The dishwasher must not be placed on top of the water hoses or the power supply cable.
-
The appliance must be connected to the water supply network by means of new pipes. Do
-
not use old pipes.
Water inlet hose connection (optional, depending on model)
Connect the cold-water supply hose to a 3/4 inch/19 mm threaded connector and make
-
sure it is securely in place.
If the water pipes are new or have not been used for a long period of time,
-
let the water run to make sure it is clean and free of impurities.
-
If this precaution is not taken, there is a risk that the water inlet will be blocked, and the
-
appliance will be damaged. (Fig. 2).
Drain hose connection
Place the drain hose of your machine into the drainpipe without kinking it.
-
When the hose is attached, the height of the outlet is between 0.5~1 metre.
-
If the length of the hose is not sufficient, you can use an extension made of the same
-
material as the original hose. Remember that the length of the hose must not exceed 4
metres, even with an extension.
BOLERO AGUAZERO 6100E/ INOX E/ DARK E
74
Publicidad
