cecotec BOLERO AGUAZERO 6100 E Manual De Instrucciones página 75

If the drain hose is longer than 4 m, the dishes will not be cleaned properly. Secure the
-
hose to the drainpipe to prevent it from coming loose during the washing process (Fig. 3).
Warning:
Please note that the drain hose cannot be disconnected, so the outlet must be fixed and
as close as possible to the dishwasher. The drain hose must be at a maximum distance of
1~1.5 metres from the dishwasher. In case the distance is longer, this will affect the draining
process of the dishwasher, causing too much wastewater to accumulate in the hose, thus
affecting the performance of the dishwasher.
Electrical connections
Before plugging the appliance into the mains, make sure that:
the plug is earthed and complies with current regulations.
-
the socket can withstand the maximum load of the appliance, which is indicated on the
-
rating plate on the inside of the door (see description of the appliance).
the supply voltage is within the values indicated on the nameplate inside the door.
-
the socket is compatible with the plug of the appliance. If not, have the plug replaced by
-
an authorised technician. Do not use an extension cord or multiple sockets.
Once the appliance has been installed, the power cable and the power socket must be
easily accessible.
The cable must not be bent or compressed.
If the power cord is damaged, it must be replaced by the official Cecotec Technical
Support Service or similarly qualified personnel to avoid any danger.
Cecotec will not be held responsible for any incidents that occur if these rules are not
followed.
Advice regarding the first wash cycle
Once the appliance has been installed, just before starting the first wash cycle, fill the
-
salt dispenser completely and add, approximately, 2.0 kg of salt (depending on the
models). Water may overflow: this is normal and not a cause for concern. It is also normal
for the LOW SALT indicator light to keep flashing for a few cycles after the salt has been
loaded.
Positioning the appliance
Position the appliance in the desired location. The back of the dishwasher must
-
rest against the wall behind it, and the sides, in the cabinets or adjacent walls. The
BOLERO AGUAZERO 6100E/ INOX E/ DARK E
ENGLISH
75