Descargar Imprimir esta página

Member's Mark Jameson SMMODTVC-2 Instrucciones De Montaje página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Step 5
Connector
Steel cable
Short screw
Wall
H6
Metal bracket
a) Ask for assistance to position the assembled unit at the desired location against a wall. Open
the door and you will see a hole at each front corner of the base, use the enclosed Hex Wrench
(H3) to turn the leveler and adjust the height of the unit, until the unit is level.
b) Now, follow the instructions printed on the plastic bag containing the Tipping Restraint
Hardware (H6) to attach the tip-over restraints to the unit and the wall.
 Unit must be placed on a level surface or leveled with included hardware (when applicable).
 Do not sit or stand on or allow children to climb, sit or stand on the assembled product.
 For safety reasons, it is imperative that this unit be mounted to the wall.
 Do not use without installing the tip restraint.
 Unit can tip over causing severe injury or death.
 Never open more than one drawer at a time.
 Do not exceed the recommended weight limits.
 Evenly distribute the weight on each level and always keep the heavier loads on the bottom.
 Before cutting, drilling or hammering into any wall or floor surface, verify the location of
electrical, plumbing and gas lines. Cutting may cause serious injury.
Wooden stud
Long screw
Need Assistance? Visit us at: samsclub.com/membersmarkhelp
Wall
Floor leveler
WARNING
H3
10 |
P a g e

Publicidad

loading