Publicidad
Thermo Scientific
Draining
Drain the bath before moving or storing.
Immediately clean up any spills on the floor to prevent a potential slip hazard.
Ensure the fluid is at a safe handling temperature, ~40°C or lower. Wear protective
clothing and gloves.
Draining
1. Place the power switch to the 0 (off) position.
2. Disconnect the power cord from the main power source.
3. Being careful to not spill the fluid from the reservoir, lift the unit and carefully dump the fluid
into the proper receptable.
4. Wipe the reservoir clean.
Draining
1. Place the power switch to the 0 (off) position.
2. Disconnect the power cord from the main power source.
3. Remove the drain hose from its storage location left of the drain quick
disconnect.
4. Insert the drain hose into the drain quick disconnect until it clicks, ensuring
that the other end is positioned over the proper receptacle.
5. When the reservoir is completely empty, press the button on the drain quick
disconnect to release the drain hose and pull free of the unit.
6. Replace the drain hose into its storage location left of the drain quick
disconnect.
7. Wipe the reservoir clean.
Storage Location
Figure 3-3 – GP Bath Drain Hose
(GP 02, GP 02S, GP 05 only)
(GP 10, GP 20, GP 28 and GP 15D only)
Installation | Section 3
Precision | 3-7
Publicidad
