Publicidad
Optional equipotential bonding system
Depending on local
building codes and regulations, have
equipotential terminal with a conductor (wire) having a nominal cross-sectional area of 2.5 mm
the household equipotential terminal. (Wire not included)
Inflation
Inflate the Spa Tub Wall
1.
Take out the ground cloth (19) and spread it over the cleared area. Then spread out the spa liner over
the ground cloth and point the drain valve towards a suitable draining area.
NOTE: Spread the ground cloth with the bubbles facing down over the cleared area where you intend
to setup your spa.
2.
Flip up the control base side cover (36) to reveal the air blower inflation outlet. Pull out the latch to open
the cover, insert the hose adaptor (24)
in place (see drawing 3).
2
1
3.
Unscrew
the air valve cap on the spa tub to reveal the
stem in the up position for inflation. Insert the other end of
the inflation hose (7) into the valve and turn to the right to
lock it in position (see drawing 4).
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
SET UP (continued)
a qualified electrician to connect the spa
with hose
and reattach the latch to the hose adaptor to secure it
4
3
5
344
English
A
2
to 6mm
2
to
3
4
1
2
7
Page 11
Publicidad
