Publicidad
4.
Press the
button to turn on the
button to inflate the spa tub wall for 8 to 10 minutes until it is firm to
the touch but not hard (see drawing
IMPORTANT: Do not over inflate or use high pressure air
compressor to inflate.
5.
Press the
button again to turn it off.
6.
Replace the air valve cap back.
The cap is designed to be screwed on and off. Never exert force
as this could cause the complete internal inflation system of the
valve to come loose. See "Spa Tub Air Valve Fastening" for valve
maintenance.
NOTE: If there is a need to replace the spa tub air pressure release
valve core (5) due to wear and tear, use the included wrench (22) to
unscrew the core from the valve base.
tighten with the wrench.
Make sure the core is securely tightened (see
drawing 7).
Inflate the Spa Cover Air Bladder
1.
Open the inflation valve and insert the inflation hose (7) into the
valve; press
to inflate until it is firm to the touch but not hard (see
drawing 8).
2.
Disconnect the inflation hose (7) from the air blower inflation outlet
and the valve.
3.
Replace the control base inflation
inflation valve.
NOTE: If there is a need to add some air to the spa tub wall
or spa cover air bladder after they have been setup, refer to above "Inflate the Spa Tub Wall" and "Inflate
the Spa Cover Air Bladder" sections. The cover air bladder is preinstalled inside the spa cover. If it needs to
be reinstalled, place the uninflated air bladder inside the spa cover lip before inflating the bladder.
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
SET UP (continued)
control panel.
Press the
5 &
6).
IMPORTANT: To prevent damage to the air
blower motor never block the air blower outlet
opening during inflation.
Insert the replacement core and
latch
back; close and recess the
English
5
22
7
Page 12
344
A
5
6
7
8
Publicidad
