Publicidad
SPA CONTROL PANEL
C
D
E
F
On/Off Button: Once the unit is plugged in, press this button to active the control panel
buttons. Press this button again to turn off all currently activated functions.
Lock/unlock Button: Press and hold this button 3 seconds to lock/unlock the control buttons.
If you forget to lock the keypad controls, the system will automatically lock it after 1 minute of
inactivity. The icon on the display is green when locked.
Control Panel Battery Indicator: The battery indicator will turn green when it is fully charged;
turn red when it requires charging and flashing red when it is in charging mode.
Water Filter Button: This button turns the filter pump on and off. The water filter icon on the
display is green when activated and flashing 002H which is the minimum preset operating
hours. Press again to increase the preset time from 002H, 004H to 006H. Pressing the button
after the maximum number of hours (006H) will turn off the filter pump and the LED display
shows the spa water temperature. If you have selected too many hours keep pressing to repeat
the cycle. Once the operating time is set, the LED display will stop flashing after 10 seconds
and the filter pump starts working. The cycle repeats itself at the same time each day for the
number hours selected.
If the heating system is activated it will override the filter pump preset time function.
To view the preset time while the filter pump is operating, press
briefly flash the preset hours for 10 seconds and then display back the remaining operating
hours. To adjust the preset time, press
previous steps.
NOTE: The built-in hard water treatment function works automatically in conjunction with the
filtration system.
Water Jet Button: Use this button to activate the jet massage system. After 30 minutes of
continues use, the jet massage system will automatically turn off. The water jet icon on the
displays is green when activated. The angle of the water jet nozzles inside the spa tub wall can
be adjusted manually.
WARNING: Do not run jet system when the cover is attached, air pressure may
accumulate inside the spa and cause irreparable damage and bodily harm.
Bubble Button: Use this button to activate the massage system, which has a 30-minute
auto-shutoff feature. The bubble icon on the displays is green when activated.
CAuTION: Do not run Bubble system when the cover is attached, air can
accumulate inside the spa and cause irreparable damage and bodily harm.
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
OPERATION
B
A
A: On/Off Button
B: Lock/Unlock Button
C Control Panel Battery Indicator
D: Water Filter Button
E: Water Jet Button
F: Bubble Button
button twice until the display is flashing and repeat
344
English
A
button, the display will
Page 16
Publicidad
