Publicidad
LED Reading
001H
002H
003H
004H
005H
006H
007H
008H
E81
E90
E91
E92
E94
E95
E96
E97
E99
END
BLANK
MINIMIzE hEAT LOSS AND ENERGY CONSUMPTION ADVICE
1) Always keep the spa cover on to minimize heat loss during heating of the spa between
uses (but not while it is being used). Ensure the cover is fitted tightly, as per manufacturer's
instructions to maximize insulation. It shall be recommended that the cover, when not in
use, should be kept off the ground to retain its cleanliness (particularly the surface in close
proximity to the water spa water surface). The cover should be stored in an appropriate
location, where it cannot be damaged, or cause damage.
2) Check the set water temperature and consider lowering it for the times when the spa will
typically not be in use.
3) Depending on external conditions, consider turning off the heater entirely if not using the spa
for an extended period of time (where the spa provides this option, but still maintains residual
disinfection/pH-values).
4) Consider that the comfortable temperature range during use may be lower than the maximum
safe temperature.
5) Use the included insulating ground cloth underneath the spa to minimize heat loss through
the bottom of the spa.
6) Maintain clean filters to preserve appropriate working conditions for the pump and avoid
unnecessary water replacement and re-heating.
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
LED CODE ChART
Operating Hour (1 hour remaining)
Operating Hours (2 hours remaining)
Operating Hours (3 hours remaining)
Operating Hours (4 hours remaining)
Operating Hours (5 hours remaining)
Operating Hours (6 hours remaining)
Operating Hours (7 hours remaining)
Operating Hours (8 hours remaining)
Transmission signal failure
Alarm Code (Low Salt Level)
Alarm Code (High Salt Level)
Water temperature too low
Water temperature is around 50°C (122°F)
Dry-fire Protection
Water temperature sensor broken
After 72 hours of continuous heating operation, the pump will hibernate
automatically. The rapid heating function is disabled.
Control panel battery has no power or in "Power Saving Mode" waiting to
be placed on the control base recessed channel.
Definitions
No water flow
System Error
344
English
A
Page 22
Publicidad
