Publicidad
SPA WATER ChEMISTRY AND BALANCE (continued)
How to adjust the spa water chemistry when the levels are off the range. CAuTION: Always follow the
chemical manufacturer's directions, and the health and hazard warnings.
Remove the spa cover to aerate the water and use the included test strips to check the chemistry level.
Ensure the chlorine level in the water is between 2-4 ppm first, as chlorine will affect the TA test result.
If the TA level (and not the pH) is higher than 120 ppm, add appropriate chemical product to lower the TA
level.
If the TA level is lower than 60 ppm, add appropriate chemical product to raise the TA level.
NOTE: After adjustment, retest the water after 24 hours and adjust again if necessary.
After the total alkalinity has been lowered to 120 ppm or raised to 80 ppm and the pH is still high or low, add
appropriate chemical product to adjust the pH level between 6.8 and 7.6.
Use the included test strips to check the water hardness level and adjust it with appropriate chemical
product.
Handle all chemicals with care and wear extra personnel protective equipment
including goggle and gloves. It is very important not to splash acid onto your skin
or clothing, or into your eyes.
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
SPA Water Adjustment
Total Alkalinity (TA) Adjustment
pH Adjustment
Calcium Hardness Adjustment
WARNING
344
English
A
Page 25
Publicidad
