Publicidad
MAINTENANCE (continued)
Spa Surround
Barefoot areas and relaxing areas around the spa shall be cleaned on a regular basis. No cleaning water
may flow into the spa or spa water cycle. The dirt and cleaning agents shall be rinsed carefully to drain in
the spa surround.
Spa Tub and Cover Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
•
Clean and dry the area to be repaired thoroughly.
•
Remove the patch backing paper and press patch firmly over the puncture. Smooth out the surface to
remove any air bubbles under the patch.
In regions subject to freezing temperatures, drain, clean, disassemble and properly store the spa set and
related components indoors when the temperature drops below 4°C (39°F).
1.
Drain and clean the spa following the "Spa Tub Drainage" and "Spa Tub Cleaning" sections.
2.
Reverse set up instructions to deflate and disassemble the spa tub, spa control unit and spa cover air
bladder.
3.
To deflate the tub and the cover air bladder:
a) Open the deflation outlet cap (34) with the included bolt
wrench (6) (see drawing 17).
b) Insert deflation hose adaptor (35) into the deflation outlet.
c) Insert inflation hose (7) over the deflation hose adaptor (35).
d) Insert the other end of the inflation hose into the tub air
valve or cover air bladder valve.
e) Press the air bubble
f) When deflation is completed reverse above steps and
ensures the deflation outlet cap (34) is securely fastened.
Caution: Only use for the purpose described in this manual.
Keep the inflation hose away from water or small objects
when the deflation function is activated to avoid damage to
the blower motor.
4.
Make sure all the spa components and accessories are
thoroughly clean and dry before storage. Air-dry the spa tub
in the sun for an hour before folding.
5.
Fold the spa tub loosely and avoid any sharp corners to
prevent damage or leakage to the spa tub liner.
6.
Prepare additional new cartridges for next time use.
7.
Store the spa tub and
accessories indoors,
(32º – 104ºF), storage location.
8.
The original packing can be used for storage.
S AVE THESE INSTRUCTIONS
(344IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2019
STORAGE
button to deflate.
in a dry, temperature controlled, between 0º – 40ºC
English
17
1
34
6
2
35
3
7
Page 29
344
A
Publicidad
