Costway TQ10198 Instrucciones De Montaje página 5

Charge the Battery
The first charge will take about 12 hours.
Charge the battery directly from the socket near the seat.
• Plug the battery connector into the charger port.
• Plug the charger Into a standard wall outlet. The charger may feel warm during
charging.
• Only use the 6 volt charger to charge your 6 volt battery.
• Note: if power flow to the wall outlet is controlled by a switch , make sure the
switch is "ON"
• Before first-time use, charge the battery for at least 12 hours. Never charge the
battery longer than 24 hours.
• Recharge the battery for at least 8-10 hours after each use of your vehicle.
• Do not charge or store battery upside down. Charging produces explosive gases.
Charge away from flames, sparks and lit cigarettes. Charge in a well ventilated area.
• Once the battery is charged, disconnect the battery connector from the charger
connector. Unplug the charger from the wall outlet. The battery is now ready to be
installed in your vehicle. Please see the following Battery installation Section for
detailed instructions on installing your vehicle:
PART LIST
• Please identify all parts before assembly and save all packaging material until
assembly is completed to ensure that no parts are discarded.
• Metal parts have been coated with lubricant for protection during shipment. Wipe
all metal parts with a paper towel to remove any excess lubricant.
08
A
1
M ai n body
Front component
D
1
Sea t
G
1
Manual
Assembly
1
Screw
(4x 16mm)
Rear window Assembly:
Place the rear window to the right place
and fasten it with two screws(4 x 16mm)
as picture shown.
B
1
Charge
E
1
L azyback
Rear window
H
7
Screw
(4x 16mm)
2
Lazyback Assembly:
Insert the lazyback to the rear window
as picture shown.
C
1
r
F
1
09