Rear Panel; Operation - Omnitronic CM-860 Manual Del Usuario

desired channel.
When you set the CUE MIXING-fader to PGM (CUE-buttons without function), you can cue the output
signal of the mixer.
When you set the CUE MIXING-fader to to the center position, you can cue both the channel-signal you
selected and the output-signal.

5.2 Rear panel

(38) MIC 1-SOCKET
Connect your microphone with ¼" jack plug here. The signals can be controlled via CH-1, if the LINE 1/MIC
1-switch is set to MIC 1.
(39) LINE 1 INPUT-SOCKETS
Input socket for CH-1.
(40) GND (Ground terminal)
Connect the ground lead of the turntable with this terminal. This helps to reduce humming and pop noises.
(41) LINE / PHONO INPUT-SOCKETS
Input socket for CH-2, CH-3 and CH-4. Connect turntables equipped with MM pickup cartridge to PHONO
input. CD players or Tape Decks should be connected to LINE input. Line level musical instruments with
stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs.
(42) LINE / LINE INPUT-SOCKETS
Input socket for CH-5 and CH-6.
(43) EFFECTS SEND/RECEIVE-SOCKETS
To connect your sound effectors here.
(44) REC OUT
To connect your recording unit.
(45) MASTER 1 OUT
Output sockets for connecting your power amplifier.
(46) MASTER 2 OUT
Output sockets for connecting your power amplifier.
(47) BOOTH
Connect your monitor system here.
(48) MASTER 1 BALANCED OUTPUT
Balanced output for the master 1 signal.
(49) X-START-SOCKETS
Via the Start-socket, the respective CD-player can be remotely controlled via the Crossfader. If you are using
a CD-player with Faderstart-function connect the mixer with the Control-socket. Please note that these
sockets must never be connected with any voltage.
(50) AC IN SOCKET
Used to plug the power unit in.

6. OPERATION

Switch the device on via the power switch.
As soon as the Audio-signals are present the signal level is displayed. You can adjust the level of the input
signals via the Gain-control.
21/41 10006940_V_2_3.DOC