Publicidad
Idiomas disponibles
Idiomas disponibles
o The charger unit plugged into the
AC outlet will normally become
warm
to touch
during
charging.
o
SAFE
CHARGE
- The charger
util-
izes trickle
charging,
which
is the
safest
way to charge
a battery.
The
unit will not overcharge
and can be
left on charge
indefinitely.
o
NI-MH
Green
Power-The
Clipper
utilizes
Nickel
Metal Hydride
batter-
ies. They are environmentally
safe
and do not have a memory
effect.
o
Longest
life and best performance
wilt be obtained
when
charging
in
normal
room temperature.
o
Battery
life is dependent
on usage,
storage
temperature
and time
To Operate The Combo
Clipper:
1 To turn tool ON slide the safety
switch on top of the handle FOR-
WARD with your thumb. Hold it
FORWARD
momentarily,
while
squeezing the trigger switch (located
under the handle)
See Figure 1
Figure 1.
2.. The trigger has been designed so it
is easy to hold in the ON position
during clipping. The safety switch
may be released after the trigger
switch is ON.
3. To turn tool OFF, merely release the
trigger. The locking button ,will snap
backward and prevent the trigger
switch from being accidentally
de-
pressed..
To Change
Blades:
!_ Make sure to keep your hands away
from the trigger and safety switch to
ensure the tool is not accidentally
turned ON.. Keep hands away from
the sharp edges on the blades.
4
2.
Place
the Combo
Ctipper
on a flat
surface,
3
Grip the rear of the handle
with one
hand,
while
gripping
the black re-
lease
buttons
(on each side of the
unit) with the thumb
and index fin-
ger of the other
hand,
See Figure
2.
4,
Squeeze
in and pull the release
buttons
FORWARD
and lift the tool
upward
to disengage
it from the
blade and gearbox,
See Figure
2,
Figure 2.
5
With the release
buttons
FOR-
WARD
and the other
blade
assem-
bly on a flat surface,
place the unit
on top of the black gearbox
and
gently
lower
it into place.
6.. When
the blade assembly
is se-
curely
in place
push the two re-
lease
buttons
BACKWARD
to lock
the blade
in place..
TRIM MING
TECHNIQUES
Maintain
proper
balance
at all times.
Keep hand
away from blades,
Wear
eye protection
when
using the unit,
Hold the clipper
firmly
and turn ON.
GRASS SHEAR
o The shear works best with dry grass,
but it can be used safely in wet
grass due to the low voltage design
• A long sweeping
cutting motion will
get the greatest amount of clipping
per charge_
o Feed blade into grass at a rate that
allows it to keep up cutting speed..
Feed slower if blades slow down,
• DO NOT force blade Mto the ground.
It is designed for clipping grass,
weeds, dry flowers and new shrub
growth, tt is not designed for edging.
Publicidad
