Descargar Imprimir esta página

Craftsman 580.752990 Manual Del Operador página 23

Ocultar thumbs Ver también para 580.752990:

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Pump has following problems:
failure to produce pressure,
erratic pressure, chattering, loss
of pressure, low water volume.
Detergent fails to mix with spray.
Engine runs good at no-load but
"bogs" when load is added.
Engine will not start; starts and
runs rough or shuts down during
operation.
Engine lacks power.
Engine "hunts" or falters.
TROUBLESHOOTING
Cause
1. Low pressure spray tip installed.
2. Water inlet is blocked.
3. Inadequate water supply.
4. Inlet hose is kinked or leaking.
5. Clogged inlet hose strainer.
6. Water supply is over 100°F.
7. High pressure hose is blocked or
leaks.
8. Gun leaks.
9. Spray tip is obstructed.
10. Pump is faulty.
1. Detergent siphoning tube is not
submerged.
2. Detergent siphoning tube is clogged
or cracked.
3. High pressure spray tip installed.
4. Detergent siphoning check ball
stuck.
Engine speed is too slow.
1. Throttle lever in "Stop" position.
2. Fuel lever in Off (O) position.
3. Dirty air cleaner.
4. Out of fuel.
5. Stale fuel.
6. Spark plug wire not connected to
spark plug.
7. Bad spark plug.
8. Water in fuel.
9. Overchoking.
10. Excessively rich fuel mixture.
Dirty air filter.
Choke is opened too soon.
23
Correction
1. Replace spray tip with high pressure
spray tip.
2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose strainer.
6. Provide cooler water supply.
7. Clear blocks in outlet hose.
8. Replace gun.
9. Clean spray tip.
10. Contact Sears service facility.
1. Insert detergent siphoning tube into
detergent.
2. Clean or replace detergent siphoning
tube.
3. Replace spray tip with low pressure
spray tip.
4. Free detergent siphoning check ball.
Move throttle control to FAST position. If
engine still "bogs down", contact Sears
service facility.
1. Move throttle lever to "Fast" position.
2. Move fuel lever to On (I) position.
3. Clean or replace air cleaner.
4. Fill fuel tank.
5. Drain fuel tank; fill with fresh fuel.
6. Connect wire to spark plug.
7. Replace spark plug.
8. Drain fuel tank; fill with fresh fuel.
9. Open choke fully and crank engine.
10. Contact Sears service facility.
Replace air filter.
Move choke to halfway position until engine
runs smoothly.

Publicidad

loading