Publicidad
12. MAINTENANCE TABLE
Intervention
MACHINE
Check all fasteners
Safety checks/check controls
General cleaning and inspection
13. TROUBLESHOOTING
PROBLEM
1. The machine does not work
2. The equipment stops
during the cutting
3. The cutting blade becomes
jammed in a thick branch
4. The cut is not smooth
If problems persist after having performed the above operations, contact your dealer.
(*) Interventions that must be carried out by your Dealer or by an Authorized Service Center
14. ATTACHMENTS ON REQUEST
14.1 BATTERY
Different capacity batteries are available to
suit specific operating requirements (Fig. 10).
The list of approved batteries for this machine
is found in the "Technical Data" table.
First time
PROBABLE CAUSE
- Set the ON-OFF main
switch to OFF position
- Battery empty
- Battery is not correctly inserted
- Battery empty
- Battery capacity is low
- Battery capacity is low
- Wood too hard
- Branch diameter too big
- Cutting blade is not tightened
- Cutting blade is blunt or worn
14.2 BATTERY CHARGER
Device used to recharge the battery (Fig. 11).
EN - 9
Frequency
And then after
-
Before each use
-
Before each use
-
After each use
SOLUTION
-set the ON-OFF main
switch to ON position
- Charge Battery
- Remove the Battery
and insert again
- Charge the Battery
- Charge the Battery
- Charge the Battery
- Wood is unsuitable for cutting
- Wood is unsuitable for cutting
- Tighten screw on
the cutting blade
- Replace cutting blade (*)
every
Publicidad
