Publicidad
Idiomas disponibles
Idiomas disponibles
Cross cut fence
Saw blade speed
Lock of sliding table
OPERATION
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices, electrical cables and operating
elements must be checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
•
Make sure that the saw blade used matches the set speed of the machine and that the
diameter of the saw blade is compatible with the machine.
Cracked and deformed saw blades cannot be repaired. They must be replaced
•
immediately with new saw blades.
Make sure that the machine works without vibrations.
•
Always use the riving knife and the saw blade guard. Make sure that the riving knife, the
•
saw blade guard and the height of the saw blade are positioned correctly. The riving knife
must always be aligned with the workpiece. Otherwise there is a risk that the workpiece
will stick and cause kickback.
Make sure that the workpiece is in a stable position on the table and is supported by either
•
the rip fence or the outrigger table during cutting.
HOLZMANN Maschinen GmbH
Position I: see techn. data
Position II: see techn. data
Position III: see techn. data
NOTE:
of the rocker lever, requiring no manual adjustment
The sliding table is secured laterally with a lever (1)
against accidental movement.
To loosen the locking, pull the lever out of the fixation.
www.holzmann-maschinen.at
- Position the outrigger table by loosening the
clamping lever (1) and pushing the outrigger table
into position.
- Adjust the crosscut fence by loosening the
clamping screws and moving the flip stops (3)
- Read off the set measurement from the scale (4).
- Extend the cross-cut fence by loosening the
locking knob (2) and pulling out the rail (2).
- Tighten the locking knob again.
NOTE:
If the workpiece extends more than 1950 mm,
the cross-cut fence must be extended.
- Open the maintenance door
- Rotate the rocker lever (1) downward with a
wrench to the lock position
- Position drive belt (2) on corresponding motor
belt pulley (3) and drive belt pulley (4)
- Rotate the rocker lever upward
- Close the maintenance door
Belt tension will be self-adjusted after flipping
OPERATION
54
FKS400V32PRO_400V
Publicidad
