Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure that the work table and the sliding table are parallel to the saw blade.
•
Never stand in the direct cutting line of the saw blade, do not hold any parts of your body
•
in the cutting line. Keep the side of the saw blade whenever cutting.
Never reach over or behind the saw blade with your hand while cutting.
•
Avoid awkward operations and hand positions where a sudden slip could cause your hand
•
to get caught in the rotating saw blade.
•
When using the cross-cut fence, the workpiece should not touch the rip fence at the same
time as cutting.
Use the push stick if the distance between the saw blade and the ruler of the rip fence is
•
less than 120 mm.
Use the downholder to secure the workpiece.
•
Guide the workpiece smoothly until the end of cutting.
•
Avoid jerky movements and changing direction.
•
15.2
Types of cut
Workpiece size
Larger workpieces are moved by pushing the sliding table with little effort. Smaller workpieces can
be pushed over the stationary table top, as with a table saw.
Symbolpicture
Symbolpicture
Mitre cuts
Depending on the workpiece size, set the desired angle on the mitre fence.
HOLZMANN Maschinen GmbH
Large workpieces
-
Adjust the rip fence or the cross-cut fence. If
necessary, pull out the cross-cut fence.
-
Use the downholder to fix the workpiece.
-
Use the sliding table to move the workpiece.
-
For removal widths less than 120 mm, use the push
stick.
-
Angle: Adjust the angle with the cross-cut fence.
Smaller workpieces
-
For smaller workpieces, use the mitre gauge. Set the
mitre gauge to 90° to the saw blade and place the
workpiece against it. The rip fence can be used to
support this.
-
Use the pushing stick.
-
Push the workpiece evenly with the pushing stick.
-
Angle: Set the angle with the mitre gauge. You can fix
the angle stop in the groove of the worktable or the
sliding table.
Mitre gauge
-
Loosen clamping lever (1) and clamping screw (1) and
set the desired angle.
-
Fix t clamping lever and clamping screw again.
- Adjust the mitre gauge by loosening the clamping
screws and moving the flip stops (4).
- Read off the set measurement from the scale.
- Extend the mitre gauge by loosening the locking
knob (2) and pulling out the rail.
- Tighten the locking knob again.
www.holzmann-maschinen.at
OPERATION
55
FKS400V32PRO_400V
Publicidad
