Use Of The 12V Dc Outlet - MAG MG1000 Instrucciones De Uso

NOTE: Devices that use an engine such as compressors, water pumps,
saws, radials, etc. require up to 3 times more power for startup. For example, a
500 W water pump would need a 1500 W generator for startup. Verify that
charges upon connection do not exceed the maximum power of the group
according to this guideline.

6.1 Use of the 12V DC outlet.

NOTE: The 12V direct current outlet is only valid for 12V battery charging.
Do not connect 12V electrical or electronic devices to the generator.
1 First connect the clamps in the battery terminals.
2 Then connect the charging cable to the 12V connection of the generator panel.
3 Start the generator.
12V CONNECTION
CAUTION: Connect the red cable (+) to the red terminal (+) of the battery
and the black cable (-) to the negative (-) of the battery.
CAUTION: In order to avoid sparks in the battery terminals, first connect
the charging cable to the battery terminals and then plug to the generator. Upon
removing, first unplug the generator cable.
CHARGING CABLE
CHARGING CLAMPS
BATTERY TERMINALS
12