ErgoAV ERMML4-01B Manual De Instrucciones página 9

Supplied Parts and Hardware for Step 2
Lag Screw
A1 x 4
5/16" x 2 3/4"
Wall Anchor
x 4
A2
10 x 60mm
NOTE: The Lag Screw [A1] shown is actual size.
This Wall Anchor [A2] is
for use in concrete walls
only. DO NOT use them in
drywall or wood studs.
Wall Plate
02 x 1
CAUTION!
1.
OR
Use a stud finder (not included) to locate
wood studs or use an awl (not included)
to verify the edges. Mark the edge and
center locations.
XXX-XXXXX-XX Rev00
Wall Plate Template
NOTE:
1. Before hanging the Wall Plate [02] on
the wall, you need to remove the upper
and lower covers. Install the cover after
the Wall Plate [02] is installed.
2. Pay attention to the upper and lower
positions of the wall panels, and reverse
installation is prohibited.
08
Complete Step 1 in owner's manual before mounting wall plate.
16" (406.4mm)
2. 3. 4.
03
A1 02
Position the Wall Plate Template [03] at Drill pilot holes using a 7/32" (5.5mm) Install the Wall Plate [02] using Lag Screws
your desired height and line up the holes diameter drill bit. Make sure the depth [A1]. Tighten the Lag Screws [A1] is pulled
with your stud center line. Level the Wall is not less than 2 3/4" (70mm). firmly against the Wall Plate [02]. DO NOT
Plate Template [03] and mark the holes. over-tighten the Lag Screws [A1].
Level Pencil Electric Drill Level
(Not Included) 2 3/4" (70mm） (Not Included)
(Not Included) (Not Included)
Questions or Need Help
ErgoAV Customer Care Phone: (877) 419-7832 support@ergoav.com
24in (609.6mm)
03 x 1
1/2" (13mm)
Socket Wrench
(Not Included)