Publicidad
Idiomas disponibles
Idiomas disponibles
WF 1045 – WF 1050
STEP 4
Mark the position of the 4 screws that will hold the fan, drill the four holes and install the screws. Secure the
wall plate to the fan using the shorter screw. Then hang the fan on the wall and tighten the wall screws.
INSTRUCTIONS FOR USE
1. Plug the device into power. Make sure the switch is off.
2. The speed is adjusted by pulling the speed switch. The numbers 0, 1, 2, 3 on the panel indicate off, low,
medium and high speed respectively.
3. To activate fan oscillation, pull the oscillation switch. The fan will oscillate from side to side. Pull the chain
again to stop swing mode.
4. The tilt angle of the wall fan is adjusted by loosening the bracket screw. Adjust the angle to the desired
position and retighten the screws.
12
Publicidad
