Cameo PIXBAR G2 Manual De Usuario página 15

DMX modes with DMX delay channel
The DMX Delay function is a simple way to create a running light effect with a large number of
identical fixtures that are running the same software version, which would otherwise require a
suitable DMX controller and extensive programming. All the lights used (same model, same soft-
ware version) are set to the same DMX mode with DMX delay channel and controlled via the same
DMX start address.
Setting the DMX delay: Select one of the DMX modes with DMX delay channel and confirm the
selection (example: D4 CH CCT).
Assign the fixtures to one of up to 24 groups (plus Group 0) according to preference, whereby se-
veral lighs can be assigned to one group. The group number is also the factor by which the delay
time set in the DMX controller is multiplied. Confirm each entry by pressing ENTER.
The delay time of the DMX signal is set by means of a DMX controller in the separate DMX delay
channel of the corresponding DMX mode (0.0 s to 2.0 s in 0.1 s increments).
Setup example:
STAND-ALONE MENU MASTER / ALONE
In the stand-alone operating modes Direct LED, CCT and Play Loop, the control signal of the corre-
sponding mode can be output to slave units via XLR (DMX OUT) and W-DMX™:
Stand Alone -> Master/Alone -> Master
If you do not want to output the control signal, deactivate the output:
Stand Alone -> Master/Alone -> Alone
15