afx light CLOUDY Manual De Uso página 3

• Do not shake the device. Avoid brute force when installing or operating it.
• Operate the device only after having familiarized yourself with its functions. Do not permit ope-
ration by person not qualified for operating the device. Most damages are the result of unprofes-
sional operation.
• For safety reasons, please be aware that all modifications on the device are forbidden. Further-
more, any other operation may lead to short-circuit, burns, electric shock, crash, etc. If this de-
vice will be operated in any way different to the one described in this manual, the product may
suffer damages and the warranty becomes void.
• When you use the fog machine on a wooden floor or ground with carpet, the machine should ne-
ver be directly in contact with the ground. The machine should keep a distance with the ground
of 50cm at least. It's not allowed to put flammable and explosive objects within 5 meters
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
IMPORTANT NOTES
• Before filling the fog liquid, please unplug the unit from the mains.
• In order to prevent short circuits, please don't let fog liquid flow into the inner part of the machine
before filling, you can also take out the liquid bottle and fill in the fog liquid outside the unit.
• The fog machine must be installed on the ground. It's not allowed to slope the unit or place it
upside down
• After use, switch the fog machine off and unplug it from the mains
• The fog machine isn't waterproof. If moisture or fog liquid enters inside the machine, you must
unplug it immediately from the mains and contact your dealer.
• It's forbidden to spray directly towards persons. Keep far away from flammability and explosive
objects
• The fog spray is very hot, please keep a distance of at least 5 meters when using it
• Please don't touch the surface of the fog machine during the use because the housing will reach
40-80°C
• When the machine doesn't work, please check if the fuse is burnt out or not. If it is, replace it by
an identical fuse, find out the fault and restart the machine. But please note: the repair must be
handled by a professional.
FILLING THE TANKS
PLEASE NOTE: THE FOG FLUID AND THE WATER
MUST BE FILLED INTO THE CORRECT TANKS. PLEASE
FILL THE FOG FLUID INTO TANK 1 AND THE WATER
INTO TANK 2.
DO NOT OPERATE THE MACHINE WITHOUT
FOG FLUID AND WATER!!!
Fill in the fog liquid (tank 1)
Unscrew the cap of the fog liquid bottle and fill the fog
liquid. After filling, screw tight the cap of the fog liquid
bottle to avoid fog liquid leaking out.
Watertank (tank 2)
Open the large tank and fill in demineralised water until
the MAX level indicator on the side of the machine (3).
Close the tank and lock it with the clamps.
①
www.afx-light.com
②
③
RECOMMENDED FILL
3 EN