CAMP Druid Lanyard Manual De Instrucciones página 52

Number of descents with maximum mass and height no.: 51 max (then replace the rope)
Number of descents with the same rope and maximum mass no.: 40 max (then replace the rope)
W= 9.81 x m x h x n
O
Use as work line descender in accordance with EN 12841/C
The use of Druid Lanyard in rope access allows the user to apply his/her full weight on the rope [2]
. The device allows climbing in combination with a device in accordance with EN
be slide along the rope using the trigger [1g] as shown in . Never release the brake side rope [4] during the
loop (
anchor line.
Used as a EN 795/B
. Portable
anchor devices must be loaded by one person only. Check that the direction of loading of the connectors is
). Do not choke the lanyard ( ). Do not stay above
the anchor point: risk of failure/injuries in case of fall. Take measures to avoid pendulum. If used in a fall arrest
recommended to mark the device with the date of last inspection. Do not use the product for lifting equipment.
to 150 kg so long as the fall arrest system used in combination is suitable for this weight.
anchor points already provided on the structure. Druid Lanyard was tested for EN 795/C use by a single person at
Table D
fall.
For installation:
• Skilled individuals must perform this.
• Connect the anchoring side of the rope [3]
• Extend the rope to allow attachment between the regulator attachment hole [1c] and the second anchoring point
• Recover the slack rope by pulling on the free end [4].
• Apply a tension of about 1 kN (100 kg) on the rope. This can be obtained by a person using a 3:1 block and tackle
50