Reset; Usage; Arm - Smanos WK8000 Manual De Funcionamiento

EN

Reset

After reset,both user code and admin code and other settings will
be restored to default but the connected RFID tags are still valid.
Enter setup state, input:
When one beep is heard and the LED indicator keeps on for
10 seconds, the setup is successful.

Usage

The keypad can be used as a remote control. User code or admin
code should be input before the operation of Arm, Disarm, Stay
Mode, and Mute Mode.

Arm

Using keypad to arm
Input user code or admin code, and press
indicator flashes once and the keypad beeps once and sends arm
signal to the control panel.
19
key, the LED
When the alarm panel receives the signal, the siren will beep once.
The alarm system enters armed state.
Using RFID Tag to Arm
If direct arm is enabled,just tap the RFID tag twice within 3
seconds on the keypad to arm the system.
If direct arm is disabled,user needs to press [*]to wake up the
keypad and then tap RFID tag twice within 3 seconds on the
keypad to arm the system.
EN
20