Stiga PARK PRO 340 IX Manual De Instrucciones página 117

Always replace damaged, bent or worn cutting
means, together with their nuts and bolts, in
order to ensure they remain balanced.
IMPORTANT Always use original cutting means bearing the
code indicated in the "Technical Data" table.
7. TRANSPORT, STORAGE AND
DISPOSAL
7.1. TRANSPORT
When handling the machine, always:
1. disengage the cutting means;
2. Bring the cutting means assembly to the highest position;
3. switch off the machine and remove the ignition key
4. disengage the drive (par.4).
When transporting the machine on a vehicle or trailer, always:
• use an access ramp of suitable strength, width and length;
• load the machine with the engine switched off, with the key
removed from the ignition, without a driver and pushed by
an adequate number of people;
• close the fuel tap (if provided);
• lower the cutting means assembly;
• position it so that it does not cause a hazard to anyone;
• engage the drive (par.4);
• lock it firmly on the means of transport using ropes or
chains to prevent it from tipping over and possible damage.
8. PROBLEM IDENTIFICATION
PROBLEM
1. The console does not switch on.
2. The console does not switch on.
With main switch in "I" and key
switch in "I" the console remains
switched off.
3. The starter motor does not turn.
With the key switch set to "I", the
display turns on but pressing the
"START / STOP ENGINE" button
does not turn the starter motor.
7.2. STORAGE
When you intend to put your machine away for more than
30 days:
• Wait for the engine to cool
• Disconnect the battery cables and store it in a cool and
• Empty the fuel tank and follow all the instructions in the
• Clean the machine thoroughly.
• Check the machine for any damage. If necessary, contact
Store the machine:
• with the cutting means assembly lowered;
• in a dry place;
• protected from inclement weather;
• covered with a sheet if possible;
• in a place out of children's reach;
• making sure that keys or tools used for maintenance are
Before starting to use the machine again:
• check that there are no fuel leaks from the tubes, fuel
• prepare the machine as described in chapter "5 Use of
NOTE Ensure that the battery is fully charged at least once a
month and always before use.
NOTE Store the machine so as to avoid any risk in the event
of accidental contact with people.
PROBABLE CAUSE
Main switch in "O" position.
Badly connected battery.
Battery completely discharged.
Fuse blown.
Insufficiently charged battery.
EN - 8
dry place.
engine manual.
the authorised service centre.
removed.
stopcock or carburettor:
the machine".
SOLUTION
Set the key-operated main switch to "I".
Set key switch and main switch to "O" e:
Check the battery connections.
Recharge the battery.
Replace the fuse.
Recharge the battery.