Publicidad
Idiomas disponibles
Idiomas disponibles
•
USING THE APPLIANCE
To fill the tank, please follow the instructions below:
1.
Open the refrigerator door to access the water tank.
2.
Unscrew the cap and carefully fill the water tank through its opening to avoid splashing
(maximum tank capacity: 5.5 litres). Then screw the cap back on.
Cap
Close
Open
3.
When filling for the first time, set the temperature of the
refrigerator compartment to the coldest setting (2°C) and wait
at least 30 minutes. You can then help yourself to a glass of cool
water from the dispenser. To do this, press the glass (or another
container) against the lever as shown in the figure opposite.
•
GENERAL RECOMMENDATIONS
•
Water may run off and collect under the dispenser. If this happens,
wipe off the water with a clean cloth.
•
When filling the water tank, do not exceed the corresponding maximum level below the
tank cover.
•
Do not remove the glass from the bottom of the dispenser until the water has finished
draining.
•
Do not open the refrigerator door for the time required to cool the water, as this may
extend the cooling time. During water cooling, noises characteristic of refrigeration
equipment can be heard. This is normal.
•
Replace the water and clean the tank regularly (once a month) to avoid unpleasant odours
and taste.
•
If you are not going to use the water dispenser for an extended period of time, empty
the tank.
38
V.1.0
using the appliance
Water tank lid
Water tank
Coldest part of the refrigerator compartment
•
The symbol
indicates the location of the coldest part of the refrigerator where the
temperature is 4°C or below.
•
To ensure that it stays at the correct temperature, make sure the removable shelves
surrounding it are installed next to the stickers.
Temperature indicator
•
To keep food fresh in your refrigerator, especially if it is in the coldest part, make sure that
the temperature indicator reads "OK". If OK is not displayed, it means that the average
temperature is too high, in which case the refrigerator thermostat should be set to a
higher temperature.
Correct setting
•
Whenever you alter the temperature setpoint, you should leave the internal temperature
time to stabilise before making any other changes. The temperature should only be
changed progressively and you should wait at least 12 hours before rechecking the
temperature and making further changes.
•
It is normal for OK not to show on the temperature indicator after loading the appliance
with fresh food or repeatedly opening the door (or leaving it open for a long time); please
therefore wait at least 12 hours before adjusting the temperature.
Incorrect setting
V.1.0
using the appliance
39
Publicidad
Capítulos
Solución de problemas
