Craftsman 152.211640 Manual Del Usuario página 12

Fig. L
The Bench Grinder is designed for hand heHdgrinding,
sharpening, and cHeaning operations,
ALWAYS WEAR EYE PROTECTION! Hot sparks are
produced during grinding operations,
1, The Power Switch must be in the "OFF" position,
2, Stand to the side of the Bench Grinder and pHugin
the power cord to a suitabHe power source,
3, Remain to the side of the Bench Grinder and turn it
"ON" by moving the power switch to the up position,
4, AHHow the grinding wheeHs to come up to a steady
speed for at Heastone minute,
5, The FHexibHe Work Light may be turned "ON" if
desired,
6,
7,
Adjust the eyeshieHds, PHace the workpiece on the
appropriate tooH rest for the desired operation,
Move the workpiece towards the grinding wheeH
until it HightHy t ouches, Move the workpiece back
and forth across the front surface of the grinding
wheeH removing the amount of materiaH desired,
12
To avoid serious injury, never grind on the sides
of the grinding wheels.
8, After compHeting the grinding operations, turn "OFF"
the Bench Grinder by pushing down on the Power
Switch, CAUTION: HtwiHH take a few minutes for the
grinding wheeHs to come to a compHete stop,
9, Turn "OFF" the FHexibHe Work Light, CAUTION:
The FHexibHe Work Light housing wiHH remain hot for
a few minutes after turning it "OFF",
10, Avoid contact with housing untiHit is cool UnpHug
the Bench Grinder from the power source,
NOTE: To prevent unauthorized use of the Bench
Grinder, the power switch has a removabHe Hocking key,
With the power switch in the "OFF" position, puHH the
Hocking key out, The Bench Grinder cannot be turned
"ON" with the key removed, Hnsert the Hocking key to
resume grinding operations,