Publicidad
Idiomas disponibles
Idiomas disponibles
(5.4)
THE ON/OFF TRIGGER SWITCH
This machine is equipped with a safety start
trigger switch.
To start the tool:
• Push in the safety lock button on the side of
the handle with your thumb.
• Depress the main trigger switch to start the
motor.
WARNING: Never start the saw with the
cutting edge of the saw blade in contact with
the workpiece surface.
(5.3)
MAKING A CUT
• With the cutting head in the upper position,
switch on the motor and allow it to reach
full operational speed.
• Gently lower the cutting head.
• Introduce the blade into the material slowly,
using light pressure at first to keep the
blade from grabbing.
• Gradually increase the pressure as a blade
enters the workpiece. Do not 'force' the
machine. Let the saw blade do the work.
Note: Cutting performance will not improve
by applying undue pressure on the machine,
and doing so may cause blade and motor life
to be reduced.
• Reduce the pressure as the blade begins to
exit the material.
• On completion of a cut allow the cutting
head to return to its upper position, and
turn off the motor.
• Only remove your hands, or the workpiece
from the machine, after the motor has
completely stopped and the stationary
blade is covered by the lower blade guard.
www.evolutionpowertools.com
(6)
MAINTENANCE
(6.1)
Note: Any maintenance must be carried
out with the machine switched off and
disconnected from the mains/battery
power supply.
Check that all safety features and guards are
operating correctly on a regular basis. Only use
this machine if all guards/safety features are
fully operational.
All motor bearings in this machine are
lubricated for life. No further lubrication is
required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by
inserting pointed objects through openings
in the machine's casings etc. The machine's
air vents should be cleaned using compressed
dry air.
Excessive sparking may indicate the presence of
dirt in the motor or worn out carbon brushes.
(>6.2)
If this is suspected have the machine serviced
and the brushes replaced by a qualified
technician with Evolution recommended
brushes. (<6.2)
20
Publicidad
