Audi 8W9.071.151 Manual De Instrucciones página 30

Installation instructions - Audi A4 (8W) Avant 2016 ►
Edition 07.2015
– Hook the claw fastener -10- under the roof rail -arrow-.
– Tighten tensioning bolt -13- slightly using torque wrench-11-.
While doing this, make sure that the claw fastener -10- re-
mains hooked under the roof rail -arrow-.
– Perform the identical procedure on the other side of the vehi-
cle.
WARNING
The rubber supports -7- for the lower support bracket -6-
must sit flush against the roof rail on both sides of the
vehicle — risk of accident from the carrier unit coming
loose.
The carrier unit is seated in the correct position if:
◆ The rubber supports -7- for the lower support bracket -6- sit
flush against the roof rail -arrows-.
◆ The pins in the pin links-5- engage in the holes -X- in the
roof rail.
◆ The claw fastener -10- is hooked under the roof rail.
The carrier unit is positioned too far out if:
◆ The rubber supports -7- for the lower support bracket -6- do
not sit flush against the roof rail -arrow-.
◆ The pins in the pin links -5- do not correctly engage in the
holes -X- in the roof rail.
◆ The claw fastener -10- does not hook under the roof rail.
The carrier unit is positioned too far in if:
◆ The rubber supports -7- for the lower support bracket -6- do
not sit flush against the roof rail -arrow-.
◆ The pins in the pin links -5- do not correctly engage in the
holes -X- in the roof rail.
◆ The claw fastener -10- does not hook under the roof rail.
If the rubber supports for the lower support bracket -7- do not sit
flush against the surface, it is advisable to have the width ad-
justment checked, and corrected if necessary, by a qualified
workshop ⇒ P age 11.
Remove the roof bars for roof rail before this process.
10
4 Installing/removing the carrier units