ENGINE OIL FILTER
Replace the engine oil filter every season
or every other oil change if the tractor is
used more than 100 hours in one year.
AiR FILTER
Your engine
will not run properly
using a dirty
air filter.
Replace
pre-cleaner
after every 25
hours of operation
or every season.
Service
paper cartridge
every 100 hours of operation
or every season,
whichever
occurs
first.
Service
air cleaner
more
often under
dusty
conditions.
1.
Pull up on air filter cover handle and rotate
towards
engine.
2.
Remove
cover.
3.
Carefully
remove
air filter cartridge
and
pre-cleaner
from base.
4.
Clean
base
carefully
to prevent
debris
from falling
into carburetor.
NOTE:
If very
dirty
or damaged,
replace
cartridge.
5.
Place
new
pre-cleaner
and
cartridge
firmly
in base.
6.
Align
tabs on cover
with slots
in blower
housing
and replace
cover.
7.
Hook
handle
on cover
and
push
down
on handle
to close.
IMPORTANT:
Petroleum
solvents,
such as
kerosene,
are not to be used
to clean
the
cartridge.
They
may cause
deterioration
of
the cartridge.
Do not oil cartridge.
Do not
use pressurized
air to clean
cartridge.
Cartridge
Pre-
"-Slots
CLEAN AIR SCREEN
Air screen must be kept free of dirt and chaff
to prevent engine damage from overheating.
Clean with a wire brush or compressed
air to
remove dirt and stubborn dried gum fibers.
CLEAN AIR INTAKE/COOLING
AREAS
To insure proper cooling,
make sure the
grass screen, cooling fins, and other exter-
nal surfaces
of the engine are kept clean
at all times.
Every 100 hours of operation
(more often
under extremely
dusty, dirty conditions),
remove the blower housing and other cooling
shrouds. Clean the cooling fins and external
surfaces as necessary. Make surethe cooling
shrouds are reinstalled.
NOTE:
Operating the engine with a blocked
grass screen, dirty or plugged cooling fins,
and/or cooling shrouds removed will cause
engine damage due to overheating.
MUFFLER
Inspect and replace corroded
muffler and
spark arrester (if equipped) as it could create
a fire hazard and/or damage.
SPARK PLUG(S)
Replace spark plug(s) at the beginning
of
each mowing
season
or after every
100
hours of operation,
whichever
occurs first.
Spark plug type and gap setting are shown
in "PRODUCT
SPECIFICATIONS"
section
of this manual.
IN-LINE
FUEL
FILTER
The fuel filter should
be replaced
once each
season.
If fuel filter
becomes
clogged,
ob-
structing
fuel flowto
carburetor,
replacement
is required.
1. With engine
cool, remove
filter and plug
fuel line sections.
2.
Place newfuel
filter in position
in fuel line
with arrow
pointing
towards
carburetor.
3.
Be sure there
are no fuel line leaks and
clamps
are properly
positioned.
4.
Immediately
wipe up any spilled gasoline.
Clamp
CLEANING
• Clean engine, battery, seat, finish, etc. of
all foreign matter.
• Keep finished
surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with automotive
type wax.
We do not recommend
using a garden hose
or pressure
washer
to clean your tractor
unless the engine
and transmission
are
covered to keep water out. Water in engine
or transmission
will shorten the useful life of
your tractor.
Use compressed
air or a leaf
blower to remove grass, leaves and trash
from tractor and mower.
21