Security - Auxilab MEDIBAS+ Manual De Uso

1. Security

Medibas+ centrifuge is based on current technology and safety standards:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control and
laboratory use -- Part 1: General requirements
EN 61010-2-020:2006 Safety requirements for electrical equipment for measurement, control,
and laboratory use -- Part 2-020: Particular requirements for laboratory centrifuges
Therefore, using must be in accordance with the requirements of the design. The incorrect
or inappropriate use of the Medibas+ centrifuge will result in equipment damage or personal
injury:
● Use not in accordance with design requirements;
● Use by non-qualified or authorized operation and maintenance staff;
● User changes content inappropriately without authorization of the design;
● Not pay attention to or understand the rules of safe use.
Any person involved in use or maintenance of this equipment
must read and understand this manual and the security rules
specified in this manual.
The following safety rules and recommendations must be taken into account to avoid
accidents that could produce damages or injuries to the user of the equipment as well as
damages to the equipment or sample:
-
This manual is part of the Medibas+ centrifuge, so it should be available for all users of
the equipment.
-
The Medibas+ centrifuge has been designed to be used in biology, chemistry, genetics,
immunology, etc. At a maximum separation speed the density of the sample must no
exceed 1.2 g/cm
speed must be reduced accordingly.
-
When the Medibas+ centrifuge is working (during the process of sample separation or
with the rotor turning), the user must not stay within 30 cm around the centrifuge; also
there must not be hazardous substances or items blocking vents within 30 cm around the
centrifuge.
-
Centrifuge design is neither anti-corrosion nor explosion-proof, therefore, ensure the
environment is free of explosive or corrosive substances;
-
The use of the centrifuge is strictly prohibited with the following materials:
o Flammable or explosive materials;
o Strengthen chemical materials;
o Toxic or radioactive substances or pathogenic micro-organisms.
-
The separation of corrosive substances can cause damage and destruction of centrifuge
internal materials or weaken the rotor mechanical strength; so in case of separation of
corrosive substances they must be kept in adequate and properly protected containers.
3
; when the sample density is higher than 1.2 g/cm
- 32 -
3
the maximum rotor