Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTIONS
Before connecting the
torch, switch off the
power source, disconnect
the power plug and
switch off the gas supply.
USE
Make sure that the wire
liner and contact tip
match the diameter of
the filler wire.
MAINTENANCE
Turn off the power
source before perfoming
torch maintenance.
Replacement of any
spare parts or other
maintenance must be
performed after the
torch has cooled down.
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice. © 2022 Trafimet Group SpA
Before connecting
the torch to the
power source,
check the correct
electrical connections
according to the
enclosed wiring
diagrams, where
applicable.
Do not bend cables and
hoses in order to avoid
damages that may prevent
proper gas and coolant
circulation.
Replace the contact tip if
it is worn or damaged.
Replace the wire liner if
there are problems with
the wire feed.
Do not use the torch
for purposes other than
welding.
Clean the gas nozzle and
gas diffuser periodically.
Use anti-adhesive spray.
Check the condition of
the cable and handle
periodically. Repairs
may be carried out by
qualified personnel only.
Always use the original
Trafimet spare parts and
consumables.
Publicidad
