Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble auxiliary handle (see Figure 3)
Assemble the protective cover (see Figure 4)
3) Hold the machine shelf, fitting the protective cover in the machine shelf.
4) Align the protective cover and the machine shelf together with the screw.
Connect the power plug and extension cable (see Figure 5)
Operation
Switching the trimmer on: Press switch trigger (4) on the handle.
Switching the trimmer off: Release the switch trigger (4) on the handle.
Warning! Cutting elements continue to rotate for a moment after the motor is switched off.
Warning! Always switch off machine before placing it down.
Cutting (trimming): Hold the trimmer in front of the body at an inclined angle and guide in a semicircular motion
around the standing position. Good cutting performance up to a grass height of 15cm. Cut down higher grass in stages.
CAUTION: Don't bring the top of the wire spool housing into contact with the ground when the machine is running.
If poor cutting performance is occurred. (see figure 6)
3) As the machine is running, tap the top of the wire spool on firm surface.
4) The blade inside of the protective cover will cut the nylon thread to the correct length.
If the tool is vibrating. Clean the tool; remove grass in between the reel fixture and the cover.
Replace the spool of nylon line (see figure 7)
Publicidad
