Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ERGOFRESH MIG WELDING TORCH
INSTALLATION
Installing and replacing wire liner
ERGOFRESH MIG welding torches are
delivered with the wire liner preinstalled.
Refer to this section when the wire liner
needs to be replaced. The wire liner is
a consumable part, which needs to be
changed if worn and when the filler wire
material changes.
1. Straighten the welding torch cable and
remove the liner nut.
2. Remove the gas nozzle and the contact
tip. If the wire liner does not pass
through the tip holder, remove the tip
holder as well.
3. Cut the wire liner leaving 1-2 mm of
excess liner.
4. Remove any rough edges that could
potentially damage the filler wire.
5. Screw the liner nut back in place and
tighten it with a tool.
Installing and removing grip handle
1. Keeping the bottom of the grip handle
pointing forward, fit the grooves of the
grip handle over on the torch handle.
2. Pull the handle backward to lock it in
position.
3. To remove the grip handle, press the lock
button in the grip handle rear.
1
4
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice.
If you change the filler wire to a different diameter or material, change also the feed
rolls in the wire feed system accordingly.
The filler wire must be removed before the wire liner replacement.
1
2
3
4
5
2
© 2023 Trafimet Group SpA
1 - 2 mm
3
1 - 2 mm
Publicidad
