Publicidad
Idiomas disponibles
Idiomas disponibles
In order to know more about the product
features, see table 01 on page 5.
ASSEMBLY AND INSTALLATION
Before unpacking the product, memorize
the position of each accessory in case you
need to repack it in the future.
Do not lift or pull the door or the door
handle during transport and do not use it
as a support.
Do not tilt the appliance more than 45º
(with respect to the vertical alignment)
and avoid any shaking or hitting.
If you notice any type of damage or
malfunctioning, get in touch with the
seller.
• The manufacturer will not be held
accountable for any damage caused by
an incorrect installation.
• Do not try to move the appliance by
yourself, at least two people are needed
to move the appliance (otherwise
injuries could be caused)
• Remove all protective sheets and
adhesive tape before using it for the
first time.
• The voltage in the room must be in
accordance with the voltage of the
appliance.
• The assembly and installation must
be carried out by a skilled technician,
who will be responsible for the correct
operation of the appliance in the
installation area.
• Select a well ventilated place where
the
appliance
direct
sunlight,
of humidity, which can cause the
appearance of stains.
• If the appliance falls over for any reason,
wait 10 minutes before putting it back
in the original position. This way the
pressure of the refrigerant System will
recover the balance before you connect
is
not
exposed
high
temperatures
it again.
• If you are going to move the appliance,
unplug it from the power supply and
take out all the food .
Appliance position
• Good ventilation around the refrigerator
is required to allow easy dissipation of
heat, freezing high efficiency and low
energy consumption. For this purpose,
you should leave around the fridge
enough open space. It is recommended
to keep 100 mm between the back of
the refrigerator and the wall at least 100
mm of space between the sides and the
obstacle or wall 200mm above the top
of the appliance and free space in the
front to allow opening doors.
• Do not pull or bend the power cable
while the device is working. In addition,
it is forbidden to keep the power cable
by the compressor at the back of the
refrigerator, as the surface temperature
is quite high when the device is turned
on.
• Place the appliance away from sources
of heat and direct sunlight.
• The ground on which the refrigerator
will be placed must be smooth and
solid. Do not place the unit on any soft
material such as foam, plastic, etc. In
the event that the appliance is level,
tighten the screws until it succeeds.
• Please, do not place the refrigerator near
any volatilizable or combustible product
such as gas, petrol, alcohol, lacquer and
oil. These objects / materials can not be
placed either inside the refrigerator.
• The appliance can not be placed in
a horizontal or inclined position at
an angle greater than 45 degrees
and cannot be placed in the opposite
to
position (face down).
Door
La puerta de este producto no es reversible..
Information about climate classes (See
picture 02 on page 4)
• Extended temperate (SN): this class
is intended to be used at ambient
EN
33
Publicidad
