Salicru SPS.ADVANCE RT2 Manual De Usuario página 49

Fig. 8. Vertical tower-type mounting.
5.1.5.4. Rotation of the control panel with LCD
display.
Fig. 9. Rotation of the control panel with LCD display on the
plastic front trim.
The device is initially set up at the factory for installation as a
•
USER MANUAL
rack. To facilitate the reading of messages on the display when
the device is installed vertically, it is advisable to rotate the
control panel clockwise by 90º (see ).
Proceed as follows:
•
Insert fingertips into the recesses of the plastic trim around
ˆ
the display and pull outwards.
Rotate the control panel with LCD display 90º to the right
ˆ
with respect to its initial position and insert it back into
the front.
Likewise, it is recommended to reverse the rotation of the con-
•
trol panel if a device arranged as a tower needs to be installed
as a rack.
In this case, the rotation of the control panel will be anti-clock-
wise.
5.1.5.5. Vertical tower-type mounting with backup
extension (battery module).
The description in this section refers to a device with a single
•
battery module. For a greater number, proceed in a similar way.
Take the 4 plastic pieces in the form of an angle supplied with
•
the UPS and the two extensions supplied with the battery
module, and install them to obtain two bases to hold the device
and the battery module.
Place the UPS and battery module upright between the two
•
bases (see Fig. 8) and at a distance of 70 mm from each end,
as shown in Fig. 6.
Rotate the control panel according to section .
•
Fig. 10. Vertically mounted tower-type model with backup exten-
sion (battery module).
5.1.5.6. Preliminary considerations before
connection.
Check that the information on the device's nameplate is that
•
required for installation.
All devices in the range feature a cord with plug for the input
•
and IEC connectors for the output, as connecting elements
SPS.ADVANCE RT2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
49