HAMPTON BAY DSHD33258H Guía De Uso Y Mantenimiento página 5

Installation
1
Preparing the glass panels
□
Unscrew the four mounting balls (1) from the fixture body (A).
□
Remove the cage (2) from the fixture body (A) and keep the
cage (2) and four mounting balls (1) for later use.
□
Place the glass panels (B) into the cage (2) and secure them
with the metal tabs.
□
Repeat this step for the remaining glass panels (B).
□
Rotate the ring to the top of the cage (2).
3
Making the electrical connections
□
Ground Wire:
□
Connect the fixture ground wire to the supply ground wire with a
wire connector (BB).
□
Supply Wire:
□
Connect the supply white wire to the white fixture supply wire
with a wire connector (BB).
□
Connect the supply black (or red) wire to the black fixture supply
wire with a wire connector (BB).
□
Wrap each connection with approved electrical tape and carefully
insert all of the connected wires into the post fitter of the fixture
body (A).
2
B
Tab
A
1
Tab
2
Preparing the fixture body
□
Carefully fit the post fitter of the fixture body (A) over
the end of the post (not supplied), making sure the post
fitter is fully seated.
□
Mark the drill point for the 3 mounting screws (AA)
using 3 mounting holes as reference.
□
After marking hole locations, remove fixture from post
and drill 1/16 in. pilot holes for screws.
5
Please contact 1-855-HD-HAMPTON for further assistance.
A
Post
A
BB
HAMPTONBAY.COM