poolstar Waterflex Falcon Air Manual De Usuario página 20

Check the pH of the water on each utilisations. The pH water should be between 6.7 and 7.6.
Any damages caused by a wrong pH balance cancel the warranty.
The bike is made of anodized aluminium and marine quality AISI 316L stainless steel. Its anti-cor-
rosion treatment makes it suitable for chlorinated water, seawater and thermal waters. It does not
require any special care in pH-controlled water (6.7 / 7.6).
1. Remove the bike after every use, rinse it with soft water, and wipe it.
2. Regularly check the pH of your swimming pool (pH 7.2 advisable)
3. Remove the bike during manual dosages of chemical products or impact treatments. Keep the
bike away to avoid any splashes that can stain or any deposits (due to the concentration of che-
mical products).
4. Deposits of powder, salt, corrosive products that encourage the corrosion process.
5. When first cleaning the surfaces of the swimming pool (before filling it) as well as subsequent
maintenance cleaning, it is advised that you remove the bike from the pool so as to avoid any
risk of stains or deposits.
6. When you are not using the bike, it must be rinsed thoroughly with soft water, then dried and
stored in a location away from chemical products, as well as equipment used for dosing chemi-
cal products for pool maintenance.
7. If there are lime-scale deposits or stains, these can be removed with a cleaner for anodized alu-
minum and a non-abrasive soft cloth. Then wash with clean water and dry it completely.
8. When you put the bike on the water, hold back the bike to prevent impact and damage to your
pool or your bike.
The safety level of the equipment can only be maintained if it is regularly checked for damage and
wear: pedal tightness, saddle and seat tube tightness, handlebar tightness, frame tightness.
Replace defective components immediately and/or take the equipment out of service until it has
been repaired.
Use original parts to maintain your bike.
For sustainable use of your bike, please follow these instructions :
- Regularly check the pH of your pool water. It must be between 6.7 and 7.6.
- In case of water shock treatment, please get out the bike from water.
- Avoid placing the bike too close of run-back nozzle.
- Leave a free area of at least 60 cm around the product.
- Get out the bike of water after each use and rinse with clear water.
20 | EN
m
aintenance adVice
WARNING
(For anodized aluminum, inox parts, and silicone parts)