Descargar Imprimir esta página

Tunturi PLATINUM SB20 SPRINTER BIKE Manual Del Usuario página 19

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 55
In Watt mode, the tension will be adjusted automatically to an
insensitivity in where the Watt reaches the Pre set Watt target�
NOTE
• The Watt parameter is a calculation of RPM and Tension level�
When RPM is higher, the tension will be lower�
When RPM is lower, the tension will be higher�
Recovery
- The Recovery key will only be valid if pulse is detected�
- Time will show „0:60" (seconds) and counts
down to 0�
- Computer will show F1 to F6 after the countdown to test heart rate
recovery status� User can find the heart rate recovery level based
on the chart below�
- Press Recovery key again to return to the beginning�
How to read the test result�
The result is based on your cardiac heart rate condition� When being
active your heart rate increases in Beats Per Minute (BPM)�
When you end your workout, your heart rate will stabilize to normal�
The faster your heart-rate stabilizes the better your cardiac condition�
When your heart rate drops with at least 50 BPM in the test minute,
your result will read F1�
When your heart rate drops in between 41~50 bpm in the test
minute, your result will read F2�
And so on�
F1
Outstanding
F2
Excellent
F3
Good
F4
Fair
F5
Below average
F6
Poor
NOTE
• When your heart rate increased in the test minute, it will read F6
too�
• When entering Recovery mode, the workout will be paused�
• Press Start/ Stop to resume training when exit Recovery mode,
or press Reset to go back to start menu�
Bluetooth & APP
- This console can connect with an APP on a smart device by
Bluetooth (iOS & Android)�
- Establish the Bluetooth connection only via the connection mode
on the installed APP on your smart device�
- When the bluetooth connection between APP and console is
establisched the console display will be dimmed�
NOTE
• Tunturi only provides the option to connect your fintess console
throughout a bluetooth connection� Therefore Tunturi cannot be
held resposible for damage, or malfunctioning of products other
than Tunturi products�
• Check the website for extra information�
This console can receive a Bluetooth heart-rate transmitter� There is
no need to pair the defice, as the console will auto detect the heart-
rate transmitter when it is in range�
50+ BPM
41 ~ 50 BPM
31~ 40 BPM
21 ~ 30 BPM
11 ~ 20 BPM
0 ~ 10 BPM
1 9
Cleaning and maintenance
The equipment requires very little maintenance, please follow up on
below instructions� The equipment does not require recalibration
when it is assembled, used and serviced according to the instructions�
WARNING
• Do not use solvents to clean the equipment�
• Clean the equipment with a soft, absorbent cloth after each use�
• Regularly check that all screws and nuts
are tight�
Defects and malfunctions
Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment� In most cases, it will
be sufficient to replace the defective part�
- If the equipment does not function properly, immediately contact
the dealer�
- Provide the model number and the serial number of the equipment
to the dealer� State the nature of the problem, conditions of use
and purchase date�
Trouble shooting:
- When the display of LCD is dim, it means the batteries need to be
changed�
- If there is no signal when you pedal, please check if the cable is
well connected�
NOTE
• When stop training for 4 minutes, the main screen will be off�
• If the computer displays abnormally, please re-install the
batteries and try again�
Shaky or unstable feeling during use
If the machine feels unstable or unstable during operation, it is
advisable to adjust the support feet to bring the frame to the correct
height� Read the instructions in this manual in section: "Use"
Transport and storage
WARNING
• Carry and move the equipment with at least two persons�
- Remain standing in front of the equipment on each side and take
a sturdy grip at the handlebars� Tilt the front of the equipment
so as to lift the rear of the equipment on the wheels� Move the
equipment and carefully put the equipment down� Place the
equipment on a protective base to prevent damage to the floor
surface�
- Move the equipment carefully over uneven surfaces� Do not move
the equipment upstairs using the wheels, but carry the equipment
by the handlebars�
- Store the equipment in a dry place with as little temperature
variation as possible�
English

Publicidad

loading