Types Of Work; Removing Screws - Hilti SD 5000-A22 Manual De Uso

▶ Use the universal hook only when necessary. Lay the screwdriver down
in a safe place when it is not in use for a long period.
5.7 Changing the accessory tool.
1. Pull the depth gauge away from the power tool, releasing the snap-on
connection.
2. Push the chuck towards the screwdriver, turning the chuck slightly at the
same time, and then hold it in this position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool in the chuck, pushing it into the
screwdriver as far as it will go.
5.8 Forward / reverse
The control switch is locked when the forward / reverse switch is in the
middle position (safety lock).
▶ Set the forward / reverse selector switch to forward or reverse rotation.
6

Types of work

ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Driving screws
WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into
a concealed electric cable and, at the same time, the bit holder or depth
gauge is touched.
▶ Hold the screwdriver only by the grip when driving or removing screws.
1. Set the screwdriver to forward rotation.
2. Check that the battery is in the working position.
3. Position the screw on the bit and bring the tip of the screw into contact
with the working surface.
4. Use the control switch to regulate the speed of the screwdriver.

6.2 Removing screws

1. Pull the depth gauge off.
2. Set the screwdriver to reverse rotation.
*2242466*
3
4
5
2242466 English 11