Operation; Activating The Drives; Positioning Drives On The Wheels - AL-KO AMS2 Mammut Tandem Manual De Instrucciones

en
Status description of contact/retract LED and keys
Fig. 4: Contact/retract LED
Each LED is allocated to one drive:
Operation LED is lit
AUS
FLASHING slowly
FLASHING quickly
ON

OPERATION

Activating the drives

The drives must never be activated when the caravan is coupled to the towing vehicle. Risk of damage
to the drives!
CAUTION!
Risk of crushing!
During activation, the drives are engaged with the wheels. During activation, ensure that nobody
can reach unnoticed between the drives and the tyres!

Positioning drives on the wheels

CAUTION!
The drives are not allowed to be used as a parking brake!
The numbers in brackets in this section refer to figure 2.
1. Switch on the radio remote control at the master switch (b).
All LEDs light up briefly one after another.
After that, the LED for the operating status starts to flash green.
2. Press the contact keys (f and g) at the same time.
3. Hold the bulge on the back of the remote control directly on the release switch for 5 seconds with
the keys pressed.
The drives are activated and perform a self-test.
There can be a brief sudden movement if the drives are in contact with the wheels.
Communication is established with the drives.
The operating status LED lights up continuously green.
The drives are active.
28
d Drive front left
e Drive front right
f Drive rear left
g Drive rear right
Drive retracted
Contact or retraction procedure (max. 60 seconds)
Fault → position unknown
Drive in contact
694 570_e