WARNING
Read and observe
to preveni severe personal injury or property damage.
e Check hoses, fittings, and trigger gun con-
nections daily for signs of wear, cracks and
looseness, and replace as needed.
e Make sure all switches and controls are in
the off position prior to plugging in electri-
cal cord. Do not stand in water while plug-
ging and unplugging electrical cord.
e Use UL grounded type receptacles of
proper voltage and amperage rating at all
times.
@ Keep all electrical components on machine
dry.
e Do not point wand or gun at yourself or at
any person. Bodily injury may result from
water under high pressure.
e Wear eye, hand, foot and skin protection at
all times while operating equipment.
e Avoid contact with non-insulated areas of
pressure washer to prevent the possibility
of severe burns.
@ Do not allow machine to run unattended.
@ Do not run machine indoors or in enclosed
areas where flammable vapors, (gasoline,
solvents, etc.) may be present.
@ Do not store flammable liquids (gasoline,
diesel fuel, etc.) near pressure washer or in
non-ventilated areas.
e To reduce the risk of injury, close supervi-
sion is necessary when machine is used
near children.
BW200
e Use extreme caution when moving ma-
chine over rough or uneven surfaces.
e For permanent installation consult local
building codes for installation requirement.
Licensed contractor may be required.
@ Disconnect power supply prior to perform-
ing any maintenance.
e Pressure washers produce a kickback. To
prevent personal injuries due to falls use
auxiliary safety equipment.
e Do not block or tie trigger of gunjet in open
position.
@ When applying detergents follow the safety
rules on the detergent label.
e Cleaning area should be provided with ade-
quate slopes and drainage. This will reduce
the possibility of a fall due to slippery sur-
face.
e Unauthorized machine modification or use
of non-approved replacement parts may
cause personal injury and/or property dam-
age and will void the manufacturer war-
ranty.
@ This machine has been provided with
Warning
and Instruction decals for the
safety of the operator. If these decals are
removed or become damaged they should
be replaced. Contact your dealer for re-
placement decals.
@ Use detergent from a covered D.O.T. ap-
proved container.
Page 5