Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR GENERATOR
If you have any problems operating your generator
after reading the manual, please call the generator
hetpline at 1-800-222-3136.
Grounding
The Generator
The National Electrical Code requires that the frame
and external electrically conductive parts of this
generator be properly connected to an approved earth
ground. Local electrical codes may also require proper
grounding of the unit. For that purpose, a grounding
fastener is provided on the generator housing.
Grounding
Fastener
_
\_\
Generally, connecting a No. 12 AWG (American Wire
Gauge) stranded copper wire to the grounding
fastener and to an earth-driven copper or brass
grounding rod (electrode) provides adequate
protection against electrical shock. However, local
codes vary widely. Consult with a local electrician for
grounding requirements
in your area.
Proper grounding of generator will help prevent
electrical shock in the event of a ground fault condition
in the generator or in connected electrical devices,
especially if the unit is equipped with a wheel kit.
Proper grounding also helps dissipate static electricity,
which often builds up in ungrounded devices.
To Start The Engine
CAUTION! NEVER start or stop the engine with
electrical loads connected to the receptacles AND with
the connected devices turned ON.
Disconnect all electrical loads from the generator.
Follow start instruction steps in numerical order:
1.
Make sure unit is on a level surface.
IMPORTANT:
Failure to start and operate unit on a
level surface will cause the unit not to start or shut
down during operation.
2.
Turn fuel valve to "On" position. Fuel valve handle
should be vertical (pointing toward ground) for fuel
to flow.
Fuel Valve is shown
in the On position
3.
Place choke lever in "Choke" position.
4.
Set rocker switch to "On" position.
Rocker Switch is
shown in On position
5.
Grasp recoil handle and pull slowly until slight
resistance is felt. Then pull rapidly to start engine.
6.
Move choke lever to "Run" position a short
distance at a time over several seconds in warm
weather or minutes in cold weather. Let engine
run smoothly before each change. Operate with
choke in "Run" position.
NOTE: If engine starts after 3 pulls but fails to run, or
if unit shuts down during operation, make sure unit is
on a level surface and check for proper oil level in
crankcase. This unit may be equipped with a low oil
protection device.
Connecting
Electrical
Loads
Let the engine stabilize and warm up for a few
minutes after starting.
DO NOT connect 240 Volt loads to 120 Volt
receptacles.
DO NOT connect 3-phase loads to the generator.
DO NOT connect 50 Hz loads to the generator.
Plug in and turn on the desired 120 Volt AC, single
phase, 60 Hertz electrical loads.
DO NOT OVERLOAD THE GENERATOR.
See
"Don't Overload Generator" on page 10.
Stopping
the Engine
1.
Unplug all electrical loads from unit. NEVER start
or stop engine with electrical devices plugged in
and turned on.
2.
Let engine run at no-load for two minutes to
stabilize unit's internal temperatures.
3.
Move rocker switch to "Off" position.
4.
Move fuel valve to "Off" position.
CORD SETS AND RECEPTACLES
Use only high quality, well-insulated,
extension cords
with the generator's 120 Volt electrical receptacles.
Check the ratings of all extension cords before you
use them. Extension cord sets used should be rated
for 125 Volt AC loads at 20 Amps or greater for most
electrical devices. Some devices, however, may not
require this type of extension cord. Check the owner's
manuals of those devices for the manufacturer's
recommendations.
8
Publicidad
