SOLAC SUPREME DRY Instrucciones De Uso página 13

• The humidiy range is 40% to 80%.
• Use the humidity/time selector buttons (3) to adjust the
desired humidity level. Each time you press, the humidity
% will be adjusted by 5%.
• Once you have reached the desired humidity %, stop
pressing the buttons. After 4 seconds the light indicator
will stop flashing and the display (4) will show the ambient
humidity again.
• The appliance will work until the room's humidity reaches
2% lower than the one chosen.
• When the ambient humidity is 2% higher than the
selected humidity level, the appliance will start working
again.
FAN SPEED
• Select the desired fan speed (high or low) by pressing the
fan speed button (7).
• The pilot light will indicate which speed is selected.
TIME FUNCTION
• This function can be used when the dehumidifier is on or
in stand by mode.
• When the dehumidifier is on, it's running time can be
programmed.
• When the dehumidifier is off, it can be programmed to
automatically turn on after the set time is reached.
• Press the time button (6) to iniciate this function.
• The display screen (4) will show the time that is selected.
• Adjust the desired time by pressing the humidity/time
selector buttons (3) as many times as hours needed
(1-24h).
• Each time you press, the time adjusts one hour.
• Once you reach the desired time, stop pressing the
button. After 5 seconds, the set time is confirmed.
• The light indicator above timer button will turn on.
• This function will be cancelled when the dehumidifier is
manually switched on/off, or when the water tank is full.
DRAINAGE (WATER TANK)
• When the water tank is full, the full tank indicator will turn
on.
• The appliance also emits a buzzing sound to alert the
user.
• When the water tank is full, the operation will stop.
• Proceed to remove the water tank. Place one hand on
each side of the depression areas to gently remove the
water tank.
• Pour the water out.
• Proceed to place the tank back into the appliance to
restart the dehumidifier.
DRAINAGE (CONTINUOUS DRAINAGE)
• If you do not want to empty the water tank everytime it
gets full, you can connect the drainage pipe provided (I)
(inner diameter 10mm) to the drainage outlet (G) to drain
the water continuously.
• The low end of the water pipe must be more than 10 cm
lower than the height of the water outlet.
• The end of the pipe cannot remain in water. It is highly
recommended to install it on a place that allows the water
to drain constantly.
• The water pipe must be kept smooth, otherwise the water
may not be drained properly.
ONCE THE APPLIANCE HAS BEEN USED
• Stop the appliance using the on/off button.
• Unplug the appliance from the mains.
• Clean the appliance.
CARRY HANDLES
• This appliance has two handles on the sides of the body,
which facilitates comfortable transport.
CLEANING
• Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
• Clean the electrical equipment and the mains connection
with a damp cloth with a few drops of washing-up liquid
and then dry. DO NOT IMMERSE IN WATER OR ANY
OTHER LIQUID.
• Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
• Do not let water or any other liquid get into the air vents to
avoid damage to the inner parts of the appliance.
• Never immerse the appliance in water or any other liquid
or place it under running water.
• If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration
of the appliance's useful life and could become unsafe
to use.
• Then dry all parts before its assembly and storage.
CLEANING THE AIR FILTER
• Clean the air filter every 2 weeks. If the air filter is blocked
with dust, its effectiveness will be reduced.
• To remove the air filter, first gently remove the air filter
cover (F) to access the air filter (E).
• Gently remove the air filter (E).