Hilti SFD 2-A Manual De Instrucciones página 17

▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
8.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1.1 Troubleshooting
Trouble or fault
The power tool does
not work.
The on/off button
cannot be pressed,
i.e. the button is
locked.
The battery runs
down more quickly
than usual.
The battery does
not engage with an
audible double click.
The tool or battery
gets very hot.
8.2 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
*2081399*
Printed: 07.01.2019 | Doc-Nr: PUB / 5174907 / 000 / 02
Possible cause
The battery is not fully
inserted.
Low battery.
The forward/reverse
selector switch is in the
middle position.
Very low ambient tem-
perature.
The retaining lugs on the
battery are dirty.
The tool is overloaded
(application limits ex-
ceeded).
2081399
Action to be taken
▶ Push the battery in
until it engages with
an audible double
click.
▶ Change the battery
and charge the empty
battery.
▶ Push the
forward/reverse
switch to the left or
right.
▶ Allow the battery to
warm up slowly to
room temperature.
▶ Clean the retaining
lugs and push the
battery in until it
engages. Contact
Hilti Service if the
problem persists.
▶ Pay attention to the
power and perfor-
mance rating of the
product before using
it, i.e check its suitabil-
ity for the job on hand.
See the "Technical
data" section.
English 13